Koch Chemie Motorplast engine conservator special 5 liter

Prices incl. VAT plus shipping costs
Ready to ship today,
Delivery time appr. 1-3 workdays
The naturally shining, water-displacing preservation for engines, housing parts, rubber hoses and aggregates on cars, commercial vehicles etc. with pleasant scenting.
The treated parts get back their new look.
Complete drying (no lubricating film) prevents dirt binding.
Due to the very good creep effect and the permanently elastic protective film, the units are protected against corrosion and environmental influences.
Suitable for use on dry and wet surfaces.
Temperature resistant up to 250 ° C.
With Daimler approval. p>
Motors, housing parts, rubber hoses and aggregates on cars, commercial vehicles etc. p>
p>
Recommended Use: strong> p>
Spray the pre-cleaned, wet or dry surfaces evenly with a spray bottle or with Ideally Cyclone and then let it dry. p>
Content: 5 liters p>
Check for suitability and compatibility before use. p>
Warnings according to CLP regulation: p>
WARNING / DANGER p>
H319-Causes serious eye irritation.
Applications: strong> p>
Item #: 236005 p>
Warning: strong> p>
Do not apply to areas where smoothness is undesirable. p>
P>
P101-If medical advice is needed, have product container or label at hand. P102-Keep out of the reach of children.
Wear P280 eye protection / face protection.
P305 + P351 + P338-IF IN EYES: Rinse cautiously with water for several minutes. Remove any existing contact lenses if possible. Continue rinsing.
P337 + P313-For continued eye irritation: Get medical advice / attention. p>
Super Zeug
Sehr einfach in der Anwendung mit tollem Ergebnis
Nr. 1 für einen gepflegten Motorraum
Top Produkt, meine Nr.1 wenn es um einen gepflegten Motorraum geht.
Wichtig ist natürlich davor die Motorreinigung (z. B. Greenstar K.C) dann ist das Ergebnis Topp!
Top Produkt
Sehr leicht in der Anwendung. Motor zuerst reinigen und dann noch Motorplast drauf ,fertig !
Super Optik !!!
Sollte jeder haben
Ein Traum. Motorenraum reinigen und das Motorplast aufsprühen...fertig! Genial
Wow
Super Ergebnisse ohne Aufwand
traumhaft
hammer hammer hammer mehr kann man dazu nicht sagen also Anwendung sehr leicht anzuwenden und das vorher / nachher Ergebnis ist unfassbar gut!
Bin Begeistert
Bin Begeistert von dem Produkt. Habe erst die Plastikteile mit KC GS vorgereinigt und abgetrocknet und danach ein bisschen mit wasser besprüht und danach Motor Plast drauf. Das Ergebnis war Super und ich war begeistert. Der Motor wurde in 9 Jahren nicht 1 mal gewaschen. Nun steht er wie neu da. Der Duft ist auch Super. Hat eine Duftnote wie eine Kirsche.

- H319: Verursacht schwere Augenreizung.
- P101: Ist ärztlicher Rat erforderlich, Verpackung oder Kennzeichnungsetikett bereithalten.
- P102: Darf nicht in die Hände von Kindern gelangen.
- P280: Schutzhandschuhe/Schutzkleidung/Augenschutz/Gesichtsschutz tragen.
- P305+P351+P338: BEI KONTAKT MIT DEN AUGEN: Einige Minuten lang behutsam mit Wasser spülen. Eventuell vorhandene Kontaktlinsen nach Möglichkeit entfernen. Weiter spülen.
- P337+P313: Bei anhaltender Augenreizung: Ärztlichen Rat einholen/ärztliche Hilfe hinzuziehen.
P100-Reihe: | Allgemein |
P200-Reihe: | Vorsorgemaßnahmen |
P300-Reihe: | Empfehlungen |
H300-Reihe: | Gesundheitsgefahren |
